B&K CT310 Uživatelský manuál stáhnout pdf (Strana 16)

CT600/602/610 and CT300/310 BKC-DIP Product Specific Appendices

Version 2.00.09

Updated 12/15/06

Page 16 of 48

Note 25: 0h = RS-232

1h = Any Zone On

2h = All Zones Off

3h = Selected Input

4h = Active Input

5h = Headphone (Headphone ignored in a CT300/600/602)

6h = Common Control In 1 On

7h = Common Control In 1 Off

8h = Common Control In 2 On

9h = Common Control In 2 Off

NOTE: Common Control 2 not valid for a CT300/310.

NOTE: Values 8h = Common Control In 2 On and 9h = Common

Control In 2 Off are not valid for CT310/300.

Note 26: 0h = Off, 1h = Selected Input, 2h = All Inputs

Note 27: 0h = BKC-DIP V1.0 compliant, 1h = BKC-DIP V2.0 compliant with

no attributes, 2h = BKC-DIP V2.0 compliant with attributes

NOTE: This parameter is reset to 0h after a cold/warm boot.

Note 28: 0h = Off, 1h = On

*NOTE: RF Remote currently not supported.

Note 29: 0h = -12.0 dB, 1h = -10 dB, ... 6h = 0.0 dB, ...

Ch = +12.0 dB

NOTE: The Stereo Left/Right Calibration Level is ignored by

the unit when it’s corresponding Zone Mode is set to

Mono.

Note 30: 0h = Serial Macro 0, 1h = Serial Macro 1, … FDh = Serial

Macro 253, FEh = Serial Macro 254, FFh = No Macro.

NOTE: If there is no corresponding valid Serial Macro, the

end result is the same as if set to FFh = No Macro.

Note 31: Bitmap indicating which Hardware Zones (Zones A, B, C, D, E

or F) to allow RS-232 data to be output. If the bit is set,

the data will be output.

Zone A 01h

Zone B 02h

Zone C 04h

Zone D 08h

Zone E 10h

Zone F 20h

Thus an output mask of 2Bh would allow serial port data to be

output on Zone A, Zone B, Zone D and Zone F, but NOT on Zone C

and Zone E.

NOTE: The serial port data is always transmitted out the

“primary” serial port connection, i.e. the RJ45

connector. An output mask of 00h will mask all data to

the Hardware Zone outputs, but the data will still be

transmitted to the primary serial port.

Note 32: 0h = 0, 1h = 1, … FDh = 253, FEh = 254, FFh = Global Receive

ID.

Note 33: Page and Device are merged together into a single byte, where

Page occupies the 3 most significant bits, and Device occupies

the 5 least significant bits:

ppp ddddd

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Komentáře k této Příručce

Žádné komentáře

B&K CT310 Uživatelský manuál Strana 16

Komentáře k této Příručce

Související produkty a manuály pro Přijímač B&K CT310