B&K 50 Series II Uživatelský manuál stáhnout pdf (Strana 71)

Run List

To run a list, follow the steps below:

1. From the List menu, select Recall and press . The load will prompt for the

memory location of the list to recall. Enter between 1 – 7 and press to recall.

2. Then, select On and press . The Trig annunciator will appear, and the On

selection will become Off.

3. Press to go back to the normal display, which will then look like the following:

4. Press to enable (ON) the load’s input, and send a trigger to initiate the start of

the list program.

5. If Trigger Source is set to Manual, press and then to send a trigger. Refer to

“Configure Trigger Source” in section “3.3 SYSTEM Menu” to configure the Trigger

Source.

Note: The number next to LIST on the display shows the current running step number.

When the list ends, it will change back to “0”.

Note: If List mode is enabled, the Recall menu will be locked and list parameters cannot be

changed until List mode is disabled.

Note: At the end of a list operation, the load’s input does not disable automatically and

will continue to draw power at the list’s last step value until is pressed to

disable the input or if controlled remotely, the input OFF command is sent at the

end.

80.000V

12.000A

0.00 W 00000.0S 0 LIST 1

T r i g

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 101 102

Žádné komentáře

B&K 50 Series II Uživatelský manuál Strana 71